Free questions

Steel Structures MCQs with answers

171 free questions — page 4 of 4. Open one to see the correct answer and the full solution.

As per IS 800: 2007, which of the following statements is correct regarding the maximum slenderness ratio?Compression Members
As per IS 800: 2007, in case of design of steel beams, the permissible bending stress in tension and the permissible bending stress in compression…Design of Beams
Calculate the net area of the tension member consists a drilled hole of diameter 22 mm to place a M20 bolt. Take thickness of the tension member as…Design of Tension Members
If a steel column is designed for its stability, then the slenderness ratio is defined as the:Compression Members
As per Euler's theory, buckling of the long column occurs when: (Given, P = Applied axial load and P_cr = Crippling load by Euler's theory)Compression Members
The effective length ratio 'K' for a column in frame with no sideway is limited between:Compression Members
Match the following lists: List-I (Member) A. A member carrying compressive loads resulting from dead and imposed load B. A member subjected to…Compression Members
Thickness of flat lacing bars shall not be less thanBuilt-up Columns
An 18 mm thick plate is joined to a 16 mm plate by 200 mm long (effective) butt weld. What is the strength of joint if a double V butt weld is used?…Welded Connections
Consider the following statements related to principles of design of connections: 1.The centre of gravity of bolts should coincide with the centre of…Bolted Connections
Nominal shear capacity of a bolt is 82335 N. What is the design capacity of the bolt, if slip resistance is designated at service load?Bolted Connections
Which one of the following is an advantage of welded connection?Welded Connections
Consider the following statements related to lug angle: If the main member is an angle, 1.the strength of lug angles and fastener connecting lug…Design of Tension Members
The shear force for which each lacing shall be designed if two parallel systems of lacing is there in the column isBuilt-up Columns
To account for shear deformation, the effective slenderness ratio of battened columns shall be taken asBuilt-up Columns
The maximum pitch for tension and compression members respectively areBolted Connections
The minimum size of fillet weld for 20 mm to 32 mm plate isWelded Connections
What is the section modulus required to design an angle Purlin which experiences a maximum bending moment of 10 kNm, if the section is made with…Industrial Roof Trusses
Which one of the following is NOT the assumption of Euler's column theory?Compression Members
What is the approximate value of the tensile strength governed by yielding of the cross section of a roof truss diagonal 100 × 75 × 6 mm (A_g = 1010…Design of Tension Members
A tension member is made up of a single angle 200 mm × 150 mm × 15 mm with a gross area of 30 cm². Two rows of 18 mm diameter bolts (take hole…Design of Tension Members